This adapter can adapts any 2.5" form factor SAS/SATA/SSD Drive to 3.5" form factor drive, without cables or hassles.
Standard position mounting holes on Adapter's bottom and sides, equivalent to those found on a 3.5" hard drive, give you the flexibility to mount it anywhere a 3.5" drive is used.
Adapter's fixed mount connectors are attached to a simple circuit board, assuring solid connections between devices, and the outside connector is positioned to plug into a backplane as the tray is inserted.
Compatible with 3Gb/s and 6Gb/s SAS/SATA/SSD drives.
No loss in data transfer speeds—no bridge chip usedNote:This adapter can convert any 2.5" SAS/SATA/SSD drive to 3.5" form factor. However, for 2.5" SAS drives, this adapter will change dual port to single port. This is fine for most applications. But if your application requires dual port, this adapter will not work for you. And, as always, a SAS controller is required in order to support SAS drives. A 2.5" SAS drives with this adapter installed will not work on a SATA controller although its connector looks exactly the same as a normal SATA connectorModel No: ASSY 654540-001 REV BExternal Interface: SATA1、SATA2Compatible Drive Type:2.5" SATA or SAS HDD SSDDevice fit: 3.5" SATA hard hot-swappable drive bayStructure: SECC(Steel Electrogalvanized Cold-rolled Included:
2.5" to 3.5" SATA SSD HDD Adapter x1(SSD and HDD not included)
4 x Drive Mounting Screws

On Nov-05-17 at 22:37:35 PST, seller added the following information: