Whether it's clamped to a wheelchair frame, a mic stand, or the edge of a desk, a tablet mount only earns its keep if it holds the device exactly where you put it. The Mount-It! Full Motion Tablet Pole, Desk & Wheelchair Mount uses two metal ball joints and a center swivel joint to tilt, swivel, and rotate a tablet into position, then lock it there.
The 11.75 x 8.25 inch tray fits iPads, Galaxy tablets, Fire tablets, Kindles, and most phones and tablets from 6 to 14 inches, and supports bare tablets up to 1.5 kg (3.3 lbs). Many mounts built for wheelchairs and poles only grip round tubing; this one's C clamp grips both round poles and flat edges from 0.5 to 2 inches thick, and turning the clamp's grip switches between the two, so it works on a wheelchair frame today and a desk edge tomorrow.
All mounting hardware, including the tray clips, knobs, and protective pads, ships in the box, so there's nothing extra to buy and no drilling required. Loosen only the top tray knob to swap tablets in and out; tighten every other screw fully before first use, since a properly tightened clamp is what keeps the tablet steady through repositioning. This mount is designed for bare tablets only. It does not accommodate thick or ruggedized cases. Remove your tablet's case before mounting, and weigh the tablet on its own to confirm it's within the 3.3 lb limit.
Mount-It! backs this mount with a lifetime manufacturer warranty and US based product support, so a caregiver, a musician, or anyone else relying on it has someone to call long after the box is opened.
Set it once, it stays put: Dual metal ball joints and a center swivel joint deliver full tilt, swivel, and rotation, then lock the tablet exactly where you leave it, so the angle you dial in today is still there tomorrow.
Backed for as long as you own it: A lifetime manufacturer warranty and US based product support come standard, well past the short term coverage typical in this category. Every unit ships with all mounting hardware included and ready to install.
Fits tablets 6 to 14 inches: The 11.75 x 8.25 inch tray works with iPads, Galaxy tablets, Fire tablets, Kindles, and most phones and tablets in that range. Measure your device's diagonal screen size before ordering; devices over 14 inches are not supported.
Rated to hold up to 3.3 lbs, bare tablet: The tray supports bare tablets up to 1.5 kg (3.3 lbs); it's not designed to hold a tablet in a thick or ruggedized case. Weigh your tablet on its own before mounting a larger model.
One clamp for poles and flat edges alike: Turn the clamp's grip to switch between round tubing and flat shapes, so the same C clamp base secures poles, desks, or shelves 0.5 to 2 inches thick, from a wheelchair frame to a desk edge without a second bracket.
Built for caregivers, patients, and hands free work: A home health aide mounts a communication tablet on a wheelchair, a musician runs sheet music from a mic stand on stage, and someone streams a workout from a treadmill rail at the gym, same mount every time.
Ships with every tool you need: All mounting knobs, clips, and protective pads are included, so there's nothing extra to buy and no drilling required. Loosen only the top tray knob to swap tablets in or out, and tighten every other screw fully before first use.
