A laptop flat on the desk sits too low and takes up room you need. The Mount-It! Laptop Arm Mount for Desk is a laptop stand on a gas spring arm that lifts the screen to eye level and keeps the desktop open. Designed for laptops, it adjusts from 9 to 18.75 inches in height.
The arm swivels 360 degrees, tilts 90 degrees, and reaches from 10.5 to 23.5 inches, so you can pull the screen in, push it aside, or turn it toward a video call. A hex key adjusts the spring tension for heavier or lighter laptops. The 11.75 x 11 inch ventilated tray holds laptops up to 17 inches and 13.2 lbs, with side holders that open from 9.5 to 16.5 inches, traction pads, and locking buckles. Measure your laptop's width and check its weight before ordering. This mount positions a screen and is not meant as a typing surface, so use an external keyboard and mouse.
Choose the included C-clamp or grommet base, for desks up to 3.1 inches thick; the grommet base mounts through a hole in the desk. Setup goes in stages: secure the base to the desk, fit the side holders onto the tray, attach the tray to the arm's VESA 75x75 and 100x100 head with the four included screws, slide in the laptop, and set the spring tension with the hex key. Total capacity is 22 lbs, with a 13.2 lb limit for the laptop. All parts and tools needed for assembly come in the box, including a key with a Phillips tip for the tray screws. Cable management clips keep cords routed along the arm.
Mount-It! backs this laptop arm with a lifetime manufacturer and US-based product specialists available during standard business hours.
Laptop sitting too low on your desk: Raise it to eye level on a gas spring arm that adjusts from 9 to 18.75 inches and holds where you leave it. A hex key sets the tension, turning one way for heavier laptops and the other for lighter ones.
Covered for as long as you own it: Mount-It! backs this laptop arm with a lifetime manufacturer and US-based product specialists, available during standard business hours. If setup, tension, or fit raises a question, a product specialist can help.
Fits laptops up to 17 inches and 13.2 lbs: Side holders open from 9.5 to 16.5 inches wide, and locking buckles, traction pads, and tabs keep the laptop from slipping. The 11.75 x 11 inch tray is ventilated so warm air escapes beneath. Check your laptop's width and weight first.
Full motion for every working position: A 360 degree swivel, 90 degree tilt, and reach from 10.5 to 23.5 inches let you pull the screen close, push it back, or angle it toward a video call, then reposition it between sitting and standing.
Screen up high, keyboard and mouse below: This laptop stand arm is a raised screen, not a typing surface, so pair it with an external keyboard and mouse. It clamps to the desk edge instead of a riser taking up space, and cable clips route cords along it.
Clamp or grommet, both in the box: Choose the C-clamp or grommet base for desks up to 3.1 inches thick. The tray detaches from a VESA 75x75 and 100x100 head. Total capacity is 22 lbs, with a 13.2 lb laptop limit. All parts and tools needed for assembly are included.
Made for real desk setups: Remote workers running a laptop as a second screen, students, and standing desk users get a home office mount that swings out to 23.5 inches and folds back in, leaving the desktop clear for notes and accessories.
