The LTE-ANTM-D omnidirectional dipole antenna is designed for indoor use with Cisco 5G, 4G, and 3G wireless Integrated Services Routers Generation 2 (ISRs G2) and Enhanced High-Speed WAN Interface Cards (EHWICs).

The LTE-ANTM-D antenna is marked with a green band and the product ID (PID) to indicate that it supports 4G Long Term Evolution (LTE) networks. It has the following hardware features:

•Articulating Joint—It can be rotated 360 degrees and is capable of maneuvering into three stop positions: 0 degrees, 45 degrees, and 90 degrees.

•Male threaded Neill-Concelman (TNC) Connector—It lets you directly mount the antenna to any Cisco 4G and Cisco 3G wireless Integrated Services Router (ISR) EHWIC with a TNC connector (Figure 1).The threads on the connector must comply with the ANSI 7/16-28 UNEF 2B thread specification.

Figure1 Cisco LTE-ANTM-D Ominidirectional Dipole Antenna, TNC Connector, and Articulation Joint

0 degree position

TNC connector

45 degree position

Green band

90 degree position

Product ID

Articulating joint

Table1 Specifications for Cisco LTE-ANTM-D Antenna

Maximum input power

3W

Connector

TNC male

VSWR1

2.5:1 or less

Characteristic impedance

50 ohm

Antenna base and radome color

Cisco Raven Black

Antenna dimensions

9 (L) x 1.45 (W) x 7/16 in (D)
(229 x 36.8 x 11 mm)

Operating temperature

-22° to 158°F (-30° to 70°C)

Operating frequency ranges

•698-806 MHz

•824-894 MHz

•925-960 MHz

•1710-1885 MHz

•1448-1511 MHz

•1920-1980 MHz

•2110-2170 MHz

•2500-2690 MHz

Maximum Peak Gain

2 dBi

1VSWR = voltage standing-wave ratio.

Figure2 Elevation Cut (AMPS) Phi 0 Degree Plane for Cisco LTE-ANTM-D

Figure3 Elevation Cut (AMPS) Phi 90 Degree Plane for Cisco LTE-ANTM-D

Figure4 Azimuth Cut (AMPS) for Cisco LTE-ANTM-D

Figure5 Elevation Cut (PCS) Phi 0 Degree Plane for Cisco LTE-ANTM-D

Figure6 Elevation Cut (PCS) Phi 90 Degree Plane for Cisco LTE-ANTM-D

Figure7 Azimuth Cut (PCS) for Cisco LTE-ANTM-D

The Cisco 4G/3G omnidirectional dipole antenna is designed to be used with any Cisco 4G and Cisco3G wireless ISRs G2 and EHWICs with a TNC antenna connector. The threads on this connector must comply with ANSI 7/16-28 UNEF 2B thread specification. The antenna is designed to be used only indoors.

Installation Notes

This antenna is designed to be mounted directly to any Cisco 5G, 4G, or 3G wireless ISR and EHWIC router with a TNC connector by simply threading it onto the mating connector. Mount and deploy the antenna at the 0-degree position, 45-degree position, or the 90-degree position, and then change that position at will. The rotation of the antenna into the proper position can take place while the antenna is still loose on the mating connector. No software is required for this installation.